Radiancy FSD+ Manuel d'utilisateur télécharger pdf (Page 19)

To insert or replace the LUA:

Picture A Picture B

1. Turn the device off and unplug the cord from the electrical outlet�

2. Grasp the LUA by both ends and pull it out of the socket (Picture A)�

3. Line up the holes in the socket with the metal and plastic posts in the LUA and

push it gently into place (Picture B)�

4. If correctly installed, the LUA will spring back when pushed in and released�

Fuse Replacement

Should the device turn off unexpectedly or fail to operate when you have plugged it in

and pushed the on/off switch, it is possible that you may have a blown fuse� To check

this:

1. Turn the device off and unplug the cord from the wall electrical outlet�

2. Pull out the fuse drawer located at the rear part of the base� Remove the inner fuse�

Check the ﬁlament if it is severed the fuse needs to be replaced�

3. Replace the fuse with the

spare (located in the outer

bay of the fuse drawer) and

push the drawer back into

place�

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Pas de commentaire

Radiancy FSD+ Manuel d'utilisateur Page 19